PCB News - Observation Method of High Frequency Circuit in PCB Design

When we got a circuit board to be repaired, we first carefully observed its appearance. If the circuit board is burned, before powering on the circuit board, you must carefully check whether the power circuit is normal, and then power on after ensuring that it will not cause secondary damage. The observation method is a kind of static inspection method. When using the observation method, the following steps are generally followed.

The first step is to observe whether the circuit board has been artificially damaged. This is mainly from the following aspects:

1. Check if the circuit board has been dropped, causing the corners of the PCB board to be deformed, or the chip on the board is deformed or broken.

2. Observe the socket of the chip to see if it is forcibly broken due to the lack of special tools.

3. Observe the chip on the circuit board. If it has a socket, first observe whether the chip is inserted incorrectly. This is mainly to prevent the operator from inserting the chip in the wrong position or direction when repairing the circuit board. If the error is not corrected in time, when the PCB board is powered on, the chip may be burnt, causing unnecessary losses.

4. If there are short-circuit terminals on the PCB board, observe whether the short-circuit terminals are inserted incorrectly.

The repair of the PCB board requires a solid theoretical foundation and careful work. Through careful observation by the repairer, sometimes the cause of the problem can be judged at this step.

The second step is to observe whether the components on the circuit board are burnt out. For example, are the resistors, capacitors, and diodes black or muddy? Under normal circumstances, even if the resistor is burned, its resistance will not change, its performance will not change, and normal use will not be affected. At this time, a multimeter is needed to assist measurement. But if the capacitors and diodes are burned, their performance will change, and they will not be able to play their due role in the circuit, which will affect the normal operation of the entire circuit. At this time, new components must be replaced.

The third step is to observe whether the integrated PCB board on the circuit board, such as 74 series, CPU, coprocessor, AD, etc. chips, are bulged, cracked, burnt, or blackened. If this happens, it is basically certain that the chip has been burned out and must be replaced.

The fourth step is to observe whether the traces on the circuit board are peeled, burned or broken. Whether the sinking copper hole is out of the pad.

Step 5: Observe the fuse (including fuse and thermistor) on the circuit board to see if the fuse is blown. Sometimes because the fuse is too thin to see clearly, you can use an auxiliary tool-a multimeter to determine whether the fuse is damaged.

The occurrence of the above four situations is mostly caused by the excessive current in the circuit. But what is the specific cause of the excessive current requires specific analysis of specific issues. But the general idea of finding the problem is to first carefully analyze the schematic diagram of the circuit board, and then find its superior circuit according to the circuit of the burned component, and derive it step by step, and then based on some experience accumulated in the work, the analysis is the easiest Where the problem occurred, find out the cause of the failure.

The above is the observation method of high-frequency circuit in PCB design. Ipcb is also provided to PCB manufacturers and PCB manufacturing technology.