Precision PCB Fabrication, High-Frequency PCB, High-Speed PCB, Standard PCB, Multilayer PCB and PCB Assembly.
The most reliable PCB & PCBA custom service factory.
PCB Technical

PCB Technical - PCB circuit board copy method and steps

PCB Technical

PCB Technical - PCB circuit board copy method and steps

PCB circuit board copy method and steps

2021-08-23
View:467
Author:Aure

PCB circuit board copy method and steps

The first step is to get a PCB circuit board. First, record the model, parameters, and positions of all vital parts on the paper, especially the direction of the diode, the three-machine tube, and the direction of the IC gap. It is best to use a digital camera to take two photos of the location of the vital parts.

The second step is to remove all the components and remove the tin in the PAD hole. Clean the PCB circuit board with alcohol, and then put it into the scanner. When the scanner scans, you need to raise the scanned pixels to get a clearer image. Start POHTOSHOP, scan the silk screen surface in color, and save it. The file and print it out for later use.

The third step is to lightly polish the two layers of TOPLAYER and BOTTOMLAYER with water gauze paper until the copper film is shiny, put them in the scanner, start PHOTOSHOP, and scan the two layers in color separately. Note that the PCB circuit board must be placed horizontally and straight in the scanner, otherwise the scanned image cannot be used, and the file should be saved.

The fourth step is to adjust the contrast and brightness of the canvas to make the part with copper film and the part without copper film have a strong contrast, then turn the second image into black and white, and check whether the lines are clear. If not, repeat this step. If it is clear, save the picture as black and white BMP format files TOP.BMP and BOT.BMP. If you find any problems with the graphics, you can also use PHOTOSHOP to repair and correct them.


 PCB circuit board,PCB,multi-layer circuit board

The fifth step is to convert the two BMP format files into PROTEL format files, and transfer two layers in PROTEL. For example, the positions of PAD and VIA that have passed through the two layers basically coincide, indicating that the previous steps are well done. If If there is a deviation, repeat the third step.

Sixth, convert the BMP of the TOP layer to TOP.PCB, pay attention to the conversion to the SILK layer, which is the yellow layer, and then you can trace the line on the TOP layer, and place the device according to the drawing in the second step. Delete the SILK layer after drawing.

The seventh step is to convert the BMP of the BOT layer to BOT.PCB, pay attention to the conversion to the SILK layer, which is the yellow layer, and then you can trace the line on the BOT layer. Delete the SILK layer after drawing.

The eighth step is to import the TOP.PCB and BOT.PCB circuit boards in PROTEL and combine them into one picture.

The ninth step, use a laser printer to print the TOPLAYER and BOTTOMLAYER on transparent film (1:1 ratio), put the film on the PCB, and compare whether there are errors. If they are correct, you are done.

Others: If it is a multi-layer circuit board, it should be carefully polished to the inner layer, while repeating the third to ninth steps. Of course, the naming of the graphics is also different. It depends on the number of layers. Generally, double-sided circuit board copying requires Much simpler than multi-layer circuit boards. Multi-layer circuit boards are prone to misalignment. Therefore, multi-layer circuit boards should be copied carefully and carefully (the internal vias and non-vias are easy to appear Question).