PCB Technical - Four basic steps of PCB copy board

The first step of PCB copy board design: the preliminary work of PCB copy board circuit board copy board

1. Use the schematic design tool to draw the schematic and generate the corresponding network table. Of course, in some special cases, such as the circuit board is relatively simple, there is already a network table, etc., it is not necessary to design the schematic diagram, and directly enter the PCB design system. In the PCB design system, you can directly use the parts and packaging. Generate a netlist.

2. Manually change the network table. Define the pads that are not on the schematic diagram such as the fixed pins of some components to the network connected to it, and define the ground or protective ground without any physical connection. Change the pin names of some devices with inconsistent pin names in the schematic diagram and PCB package library to be consistent with those in the PCB package library, especially diodes and transistors.

The second step of PCB copy board design: draw the package library of non-standard devices defined by yourself

It is recommended to put all the parts drawn by yourself into a special design file for PCB library created by yourself.

Step three of PCB copy board design: Set up the PCB design environment and draw the printed circuit board frame with hollow in the middle, etc.

3. The first step after entering the PCB copy system is to set up the PCB design environment, including setting the grid size and type, cursor type, layout parameters, wiring parameters and so on. Most of the parameters can use the system default values, and after these parameters are set, they are in line with personal habits and do not need to be modified in the future.

4. Planning the printed circuit board is mainly to determine the frame of the circuit board, including the size of the circuit board and so on. Put an appropriate size pad on the place where the fixing hole needs to be placed. For 3mm screws, 6.5~8mm outer diameter and 3.2~3.5mm inner diameter pads can be used. For standard boards, they can be imported from other boards or PCB izards.

Note: Before drawing the border of the circuit board, be sure to set the current layer to the Keep Out layer, that is, the wiring layer is prohibited.

The fourth step of PCB copy board design: After opening all the PCB copy board library files to be used, import the netlist file and modify the part package

This step is a very important part. The netlist is the soul of PCB automatic routing, and it is also the interface between the schematic design and the impression circuit board design. Only after the netlist is loaded, can the circuit board be wired.

In the process of schematic design, ERC inspection will not involve the packaging of parts. Therefore, when designing the schematic diagram, the packaging of the parts may be forgotten. When the netlist is introduced, the packaging of the parts can be modified or supplemented according to the design situation.

Of course, you can manually generate the netlist directly in the PCB, and specify the part package.