PCB Technical - Six inspection methods for PCB board processing

Six inspection methods for PCB board processing
1. Open the PCB design drawing on the computer, light up the short-circuited network, and see where is the closest, the easiest to connect to. Pay special attention to the short circuit inside the IC.

2. If it is manual welding, develop a good habit:

1. Before soldering, check the PCB board visually, and use a multimeter to check whether the key circuits (especially the power supply and the ground) are short-circuited;

2, every time a chip is soldered, use a multimeter to check whether the power supply and the ground are short-circuited;

3. Don't throw the soldering iron randomly when soldering. If you throw the solder onto the solder feet of the chip (especially surface mount components), it will not be easy to find.

3. A short circuit is found. Take a board to cut the line (especially suitable for single/double-layer boards). After the line is cut, each part of the functional block is energized and eliminated step by step.

4. Use short-circuit location analysis instruments, such as:

1, Singapore PROTEQ CB2000 short-circuit tracker

2, Hong Kong Lingzhi Technology QT50 short-circuit tracker

3, British POLAR ToneOhm950 multi-layer board short circuit detector

5. If there is a BGA chip, since all the solder joints are covered by the chip and cannot be seen, and it is a multi-layer board (above 4 layers), it is best to separate the power supply of each chip during the design, using magnetic beads or 0 ohms Resistor connection, so that when there is a short circuit between the power supply and the ground, the magnetic bead detection is disconnected, and it is easy to locate a certain chip. Because the welding of BGA is very difficult, if it is not automatically welded by the machine, a little carelessness will short-circuit the adjacent power supply and the ground two solder balls.

6. Be careful when soldering small-sized surface-mount capacitors, especially power supply filter capacitors (103 or 104), which are large in number, which can easily cause a short circuit between the power supply and the ground. Of course, sometimes with bad luck, the capacitor itself is short-circuited, so the best way is to test the capacitor before welding.
Over the years, we are proud to maintain a 99% on-time delivery rate. We work in three shifts to ensure that your PCB can appear on your desk as planned and as early as possible. You can choose DHL and other courier services to balance speed and budget. We only use services from reliable and reputable companies.
24 hours customer service
Whenever you encounter any problems, you can contact the on-site customer service staff to reply to your emails or messages. From the moment you submit the Gerber file to the moment you receive the PCB and assembled PCB, our service staff will follow up your order with satisfaction.

Customer complaints and refunds

iPCB attaches great importance to customer satisfaction, so we have established a responsible customer complaint department. If you are dissatisfied with our products after receiving our products, you can ask us to refund to your iPCB credit account, or request to re-produce the failed order. Of course, if you are still dissatisfied with our service or have any suggestions, you can send an email to us so that we can spend more time improving our services and establishing a complete suggestion system to satisfy our customers and ensure their interests.