Новости PCB - 12 вопросов, которые необходимо учитывать при проектировании аналоговой схемы pcb

The design of analog circuits is a headache for engineers, Но это также смертельная часть конструкции! We have summarized the problems that should be paid attention to in analog circuit design and shared with you.

(1) In order to obtain a feedback PCB circuit with good stability, it is usually required to use a small resistor or choke outside the feedback loop to provide a buffer for the capacitive load.

(2) The integral feedback circuit usually requires a small resistor (about 560 ohms) in series with each integral capacitor larger than 10pF.

(3) Do not use active circuits to filter or control the RF bandwidth of EMC outside the feedback loop, but only use passive components (preferably RC circuits). The integral feedback method is only effective at frequencies where the open-loop gain of the op amp is greater than the closed-loop gain. с более высокой частотой, the integrator circuit cannot control the frequency response.

(4) In order to obtain a stable linear circuit, all connections must be protected by passive filters or other suppression methods (such as photoelectric isolation).

(5) Use EMC filters, and all IC-related filters should be connected to the local 0V reference plane.

(6) Input and output filters should be placed at the connection of the external cable, and any wire connection inside the unshielded system needs to be filtered because of the antenna effect. Кроме того, filtering is also required at the wire connections inside the shielding system of the converter with digital signal processing or switch mode.

(7) High-quality RF decoupling is required on the power and ground reference pins of analog ICs, Это как цифровая интегральная схема. But analog ICs usually require low-frequency power supply decoupling, because the power supply noise rejection ratio (PSRR) of analog components increases very little after being higher than 1KHz. фильтр rc или LC применяется к линии аналоговой мощности каждого операционного усилителя, компаратор и преобразователь данных. The corner frequency of the power filter should compensate the PSRR corner frequency and slope of the device to obtain the desired PSRR within the entire operating frequency range.

(8) For high-speed analog signals, transmission line technology is necessary according to the connection length and the high frequency of communication. даже низкочастотный сигнал, the use of transmission line technology can improve its anti-interference performance, Но если линия не совпадает, то возникает эффект антенны.

(9) Avoid using high-impedance inputs or outputs, Они очень чувствительны к электрическому полю.

(10) Since most of the radiation is generated by common-mode voltage and current, and because most environmental electromagnetic interference is caused by common-mode problems, balanced transmission and reception (differential mode) technology is used in analog circuits It will have a good EMC effect and can reduce crosstalk. The balanced circuit (differential circuit) drive will not use the 0V reference system as the return current loop, so a large current loop can be avoided, уменьшение радиоактивности.

(11) The comparator must have hysteresis (positive feedback) to prevent erroneous output conversion due to noise and interference, и предотвратить колебания в точке останова. Do not use a comparator that is faster than required (keep dV/dt within the required range, as low as possible).

(12) Some analog ICs themselves are particularly sensitive to RF fields, Поэтому, как правило, необходимо использовать миниатюрные металлические экраны, установленные на PCB, и подключать их к коллекторным пластам панель PCB подобный экрану. Примечания, to ensure the heat dissipation strip.